ADCMT 7451A - Page 144

7451A/7461A/7461P Digital Multimeter Operation Manual
6.7.4 SCPI Command Reference
6-44
5. Status command
6. Common command to IEEE-488.2 (Can be used in USB.)
Function description SCPI Command Parameter Query reply
Operation Event Enable
Register setting
:STATus:OPERation:ENABle [0|0|65535] <int_5>
Operation Event Register reading
:STATus:OPERation:EVENt? <int_5>
Questionable Event Enable
Register setting
:STATus:QUEStionable:ENABle [0|0|65535] <int_5>
Questionable Event Register
reading
:STATus:QUEStionable:EVENt? <int_5>
Measurement Event Enable
Register setting
:STATus:MEASurement:ENABle n [0|0|65535] <int_5>
Measurement Event Register
reading
:STATus:MEASurement:EVENt? <int_5>
Function description SCPI Command Parameter Query reply
Each status byte clear *CLS
Standard Event Status Enable Reg-
ister setting
*ESE {0|0|127] <int_3>
Standard Event Status Register
reading
*ESR? <int_3>
Instrument information reading *IDN? For more information
on a query response,
refer to page 6-32.
Setting the operation complete bit
(bit0) of the Standard Event Status
Register after all operations are
complete
*OPC
Processing state of the operarion is
returned
*OPC? {0|1}
(0: completed,
1: uncompleted)
Instrument initialization *RST
Service Request Enable Register
setting
*SRE [64|64|127]
(bit6 is always 1)
<int_3>
Status Byte Register reading *STB? <int_3>
Trigger command *TRG
Self-test performing and the result
reading
*TST? {0|1}
(0: Normal, 1: Abnor-
mal)
All operation completion waiting *WAI (GPIB only)