ADE Accenta G3 Engineering Information

Operator’s Program mode
The information below shows the programmable
options available and how to change them.
Once the programming mode has been accessed,
each section may be changed in any order. As
each operation is completed the system will
automatically return to top level of program
mode.
Note: When programming the system
should be in the Day mode, with the Day
and Power indicators lit.
To exit operation at any time
On pressing the Reset key you will quit the
current level of operation.
How to enter Operator’s program
mode
To enter the Operator’s program mode the
system should be in Day
mode with the Day and
Power indicator lit.
How to view the event log
The panel can hold up to 8 previous events
which can be scrolled automatically or manually.
The automatic scroll starts with the newest event
( number 8) to the oldest one ( number 1).
4PI175 issue 1_6/01 5
Accenta/Optima G3 intruder system Operating instructions
Operator’s Program mode
Reset
Quit the current function
Leave Engineering menu
D
o
wn
o
n
e
m
e
n
u
l
e
v
e
l
Prog
0 1 2 3
Tamper
Day
ZONE1-8
Momentarily On
Acknowledge
Reset
View the event log
Chime
5
6
7
2
3
4
1
8
View event 1
(oldest event)
View event 2
View event 3
View event 4
View event 5
View event 6
View event 7
View event 8
(Newest event)
Automatic event scroll
Starting from event 1 to 8
To manually scroll
Resume
automatic scroll
Zone, PA and
Tamper indicators
will be lit to
show zone in
alarm.
Flashing indicates
the first zone in
alarm.
Day indicates
status of panel
at the time of alar
m
Leave program mode
Stop event scroll / view
Tamper
Day
Tamper
Acknowledge
Tamper
Enter Operator’s program mode
Chime
Example: To view up to
8 previous events and thereafter
to stop the event scroll, Press:
Chime
Prog
0 1 2 3
Reset

ADE Accenta G3 Specifications

General

Brand	ADE
Model	Accenta G3
Category	Security System
Language	English