ADE Accenta G3 Engineering Information

How to carry out Alarm and Walk
tests
The alarm test function
allows you to test the
Strobe, Bell, Low and
high volume sounders
of the system.
The walk test function
allows each detector to
be checked in order to
verify that they are
functioning correctly.
Servicing
organisation details
Servicing organisation name:
______________________________________
Telephone number:
______________________________________
Date of installation:
______________________________________
Account Number:
______________________________________
Installation Date:
______________________________________
Bell Time:_____________________________
Bell delay______________________________
Area
protected
Program
1
Program
2
Program
3
Zone 1
Zone 2
Zone 3
Zone 4
Zone 5
Zone 6
Zone 7
Zone 8
T = Timed (Entry/Exit - Zone)
TI = Time Inhibited (Access zone to keypad)
I = Immediate (All zones armed to give full
alarm)
4PI175 issue 1_6/01 7
Accenta/Optima G3 intruder system Operating instructions
How to carry out Alarm and Walk tests
Reset
Reset
Alarm test
0
Attack
x1 for zone 1
x2 for zone 2
|
x4 for zone 4
flat x1 for zone 5
flat x2 for zone 6
|
flat x4 for zone 8
Rapid for PA
Rapid for Tamper
Zones
Strobe
Strobe test
2
Bell test
3
Low volume
sounder
High volume
sounder
4
5
Walk test
6
Strobe On
Bell on
internal low
volume sound
internal high
volume sound
Strobe On
Day
Day
Day
Day
Day
OFF
0
Day
Exit current level
Leave program mode
Day
Tamper
Attack
Acknowledge
Appropriate zone lights
are lit(latched)
Attack
Tamper
Press zero to turn off
options 2,3,4 and 5
before selecting a new one
Enter Operator’s program mode
Example: To start bell test and thereafter to stop bell test.
3
Prog
0 1 2 3
0
Reset
0
Reset

ADE Accenta G3 Specifications

General

Brand	ADE
Model	Accenta G3
Category	Security System
Language	English