3000EN Series: Installation Instructions
10-2
START SMTWTFS
HH MMAM 0010000
Start Time
01-12 = hour
00-59 = minute
0 = AM; 1 = PM
Days = place “1” under days
[∗] to continue
Enter the event’s start time and days of the week to occur.
To select days, position the cursor under the desired days
using the [∗] key to move forward, then press “1” to select the
day.
STOP SMTWTFS
HH MMAM 0010000
Stop Time
01-12 = hour
00-59 = minute
0 = AM; 1 = PM
Days = place “1” under days
[∗] to continue
This prompt appears if event “01” (relay on/off), 02 (user
access), or 03 (latch key report) was selected. Otherwise it is
skipped.
Enter the event’s stop time and days of the week to occur.
To select days, position the cursor under the desired days
using the [∗] key to move forward, then press “1” to select the
day.
This entry applies only to the following events:
1 (relay on/off)
2 (user access)
3 (latch key report)
12 (up and about)
REPEAT OPTION
0-4 X
Repeat Option
0 = do not repeat
1 = repeat schedule weekly
2 = repeat schedule
biweekly (every other
week)
3 = repeat schedule every
third week
4 = repeat schedule every
fourth week
[∗] to continue
Enter the desired repeat option for this schedule.
e.g., To make a schedule that happens everyday you would
select all days with a repeat count of 1. To make a schedule
that runs for one week then stops, select everyday with a
repeat count of 0.
RANDOMIZE
0=NO 1=YES X
Randomize
0 = no
1 = yes
[∗] to continue
This prompt appears if event “01” (relay on/off) or 11 (test
report) was selected. Otherwise it is skipped.
If selected, the scheduled start and stop times will vary within
60 minutes of the “hour” time. For example, if a schedule is
set to start at 6:15pm, it will do so the first time 6:15pm
arrives, but on subsequent days it will start anytime between
6:00 and 6:59 p.m.
NOTE: Do not use the random option if the start and stop
times are within the same “hour” setting, otherwise
unpredictable results may occur (e.g., the randomized stop time
may occur before the start time).