ASMB-785 User Manual 26
2.11 Case Open Connector (JCASE1)
JCASE1 is for chassis with a case open sensor. The defaults setting of JCASE1 is
shorted by jumper and disabled in the BIOS. Before using, please remove the jumper
and attach the appropriate cable from the chassis. Then, change the BIOS setting to
enable the case open function. Please refer to Chapter 3 BIOS Operation, section
3.2.2.6 HW Monitor. If the chassis is opened, the BIOS will inform you with a warning
message of a chassis intrusion during system reboot and post screen.
To Next Page
Loading...
Need help?
General
