PCI Communication User Manual 34
4.5.1 Status Bar Messages
BUSY: The port is currently used by another application.
FAIL: The configuration parameters are not accepted by the port.
N/A PORT: The port is not available in the system.
READY: The port is ready to run or to be configured.
RUNNING: The test is running on the port.
STOPPED: The test running on the port has been manually stopped.
4.5.2 Message Logo Messages
Port Opened: The port has been manually opened.
Port Setup Fail: The port configuration parameters are incorrect or unsupported.
Port Running: The port is running a test.
Port Stopped: The test has stopped on the port.
Tx Starting/Tx Stopped: Transmission has started/stopped.
Rx Starting/Rx Stopped: Reception has started/stopped.
Break Error: A break event has been detected on the port.
Framing Error: A timing error (i.e., from the start bit to the stop bit) has been
detected on the port.
Port I/O Error: An incorrect I/O event has been detected on the port.
Rx Overrun: Received data have been overwritten before being processed.
Rx Buffer Full Error: The buffer on the receiving end is full, meaning that newly
arrived data will be ignored.
Tx Buffer Full Error: The buffer on the transmitting end is full, meaning that data
transmitted by applications will be ignored.
LB Error - %d: Data error detected in loopback.
LB Rx Pending: Loopback mode is waiting for incoming data.
Data Setup Error: Parameter errors in the port configuration.
To Next Page
Loading...
Need help?
General
