v PCI Communication User Manual
Safety Instructions
1. Read these safety instructions carefully.
2. Retain the user manual for later reference.
3. Disconnect the equipment from any AC outlet before cleaning. Use a damp
cloth. Do not use liquid or spray detergents.
4. For plug-in equipment, the power outlet socket must be located near the equip-
ment and be easily accessible.
5. Keep the equipment away from humidity.
6. Place the equipment on a stable surface during installation. Dropping it or letting
it fall may cause damage.
7. The openings on the enclosure are for air convection. Protect the equipment
from overheating. Do not cover the openings.
8. Ensure that the power source voltage is correct before connecting the equip-
ment to a power outlet.
9. Position the power cord so that people cannot step on it. Do not place anything
over the power cord.
10. Pay attention to any cautions and warnings noted on the equipment.
11. If the equipment is not used for a long time, disconnect it from the power source
to prevent damage from transient overvoltage.
12. Never pour any liquid into the openings. This may cause fire or electrical shock.
13. Never open the equipment. For safety reasons, the equipment should be
opened only by qualified service personnel.
14. If one of the following situations arises, get the equipment checked by service
personnel:
– The power cord or plug is damaged.
– Liquid has penetrated the equipment.
– The equipment has been exposed to moisture.
– The equipment does not work well, or you cannot get it to work according to
the user manual.
– The equipment has been dropped and damaged.
– The equipment has obvious signs of breakage.
15. Do not store this equipment in an environment where the temperature may go
below -20°C (-4°F) or above 60°C (140°F). This could damage the equipment.
The equipment should be kept in a controlled environment.
16. CAUTION: The battery may explode if it is incorrectly replaced. Replace only
with the same or equivalent type recommended by the manufacturer, and dis-
card used batteries in accordance with the manufacturer's instructions.
17. In accordance with IEC 704-1:1982, the sound pressure level at the operator's
position does not exceed 70 dB (A).
DISCLAIMER: These instructions are given in accordance with IEC 704-1. Advan-
tech disclaims all responsibility for the accuracy of any statements contained herein.
To Next Page
Loading...
Need help?
General
