AEG MC 4434 - Using the Remote Control Effectively; Disposal of Batteries; System Operation; Front Panel Controls and Operation

English
82
Using the remote
• Pointtheremotedirectlyattheremotesensoronthefrontofthemachine–notattheconnecteddevices.
• Thecoverageoftheremoteisnomorethan7metrestotheremotesensoronthefrontofthemachine.
• Thecoverageoftheremotealsodependsonthelightingintheroom.
• Glare(sunorarticiallight)mustnotfalldirectlyontheremotesensor.Glarecanhaveanegativeaectonthe
eectiveness of the remote.
• Pleaseensurethatnoobstaclesliebetweentheremoteandtheremotesensoronthefrontofthemachine.
• Donotuseremotesfromseveraldevicesatthesametime,sincetheymayhaveanegativeeectoneachother.
• Onlypressbuttonatatimeontheremote.
• Highvoltagedevicesanddeviceswhichemithighfrequencysignalscannegativelyinuencethefunctionsof
the remote.
Disposal of batteries
If you replace the batteries, ensure that the used batteries are disposed of in accordance with the applicable
regulations. Do not dispose of the batteries with domestic waste. When changing the batteries, dispose of them in
accordance with the applicable regulations.
They should be deposited at the collection point provided. Only by doing this can they be safely disposed of in an
environmentally friendly manner. Do not bury or burn the batteries.
System Operation
Function buttons on the front of the machine
The function buttons on the front of the device serve the same function as the corresponding buttons on the
remote. Details can be found in the following sections.
Basic functions
POWER : Switch device on and o
1. Before you switch on the DVD system, check if all elements of the system and all external devices (e.g. a televi-
sion and /or an audio device) are correctly and securely connected to one another. Then, plug the mains plugs
from all devices into the wall sockets and switch on the connected devices.
2. Press the POWER button on the front of the system to switch the device on or o.
DVD, FM, USB/DVD/CARD: Select operating mode
Since you can use the DVD system as a DVD-Player, Radio or Playback system for connected memory devices such
as a USB drive or memory card, you must always select the correct operating mode for each of these options.
• TousethesystemasaDVD-Player,presstheDVDbuttonbeforestartingtoplayadisc.
• TousethesystemasanFMradio,presstheFMbutton.
• IfyouhaveconnectedaUSBdevicetotheUSBconnection(USBPort)oramemorycardtothememorycard
reader, press the USB/DVD/CARD button to select one of the available media using the Navigation buttons ▲ or
▼ Then conrm your selection with the PLAY/ENTER button.
See the following chapter for details.