EN
1205. 6755517_02
33
26. FUNCTIONING FEATURES
26.1. SET POINT IN COOLING MODE
26.2. SET POINT IN RISCALDAMENTO
-
memory.
26.3.
-
pressor start-ups that are too close.
- Minimum time from last switch-off 60 seconds in
cooling mode.
- Minimum time from last switch-on 300 seconds
in heating mode
26.4. CIRCULATION PUMP
The circuit board envisions an output for the mana-
Whenever alarms do not occur, the compressor
starts.
26.5.
heat exchanger from breaking due to the water
-
the heat exchanger and in inlet to the chiller is less
than +3.8°C.
determines com-
pressor block and not pump block, which remains
installed.
outlet water. Rearm is manual.
26.6. WATER FLOW RATE ALARM
series on the machine. This type of safety device
-
-
sor and pump block.
ATTENTION
11
This anti-freeze set tempera-
ture can only be varied by an
authorised after-sales centre
and only after having checked
that there is anti-freeze solu-
tion in the water system.
12
Whenever this alarm
intervenes, We advise you call
the nearest after-sales service
immediately
To Next Page
Loading...
