55
Chapter 3 Front-Panel Menu Operation
Front-Panel Menu Reference
4
3
I/O Config - Configure instrument I/O interfaces.
• Select the GPIB address.
• Specify the LAN configuration (IP address and network configuration).
Calibrate - Perform calibration tasks.
• Lock and unlock the instrument for calibration.
• Set the calibration password.
• Calibrate the instrument (see Agilent 33500 Series Service Guide).
Instr Setup - Configure instrument parameters.
•
Perform self-test.
• Configure reference oscillator.
• Clear instrument memory.
System Setup - Configure system-related parameters.
• Set screen layout.
•
Select how periods and commas are used in numbers displayed on the front panel.
• Select the local language for front-panel messages and help text.
• Enable/disable the tone heard when an error is generated.
• Enable/disable the display screen saver mode.
• Adjust the brightness setting of the front-panel display.
• Perform an instrument self-test.
• Secure/unsecure the instrument for calibration and perform manual calibrations.
• Query the instrument’s firmware revision codes.
• Install licenses for licensed features.
• Set date and time.
• Perform file management.
To Next Page
Loading...
Need help?
General
