2 Preparing the Analyzer for Use
To do the incoming inspection 2-5
To install the analyzer 2-7
To connect the analyzer to a dc power source 2-8
To change the fuses 2-10
To connect the analyzer to a serial device 2-11
To connect the analyzer to a parallel device 2-11
To connect the analyzer to an GPIB device 2-12
To connect the analyzer to an external monitor 2-13
To connect the optional keyboard 2-14
To connect the microphone adapter 2-16
To clean the screen 2-17
To store the analyzer 2-17
To transport the analyzer 2-18
If the analyzer will not power up 2-19
If the analyzer operates intermittently on dc power 2-20
3 Verifying Specifications
To load the program 3-7
To run the program in semiautomated mode 3-8
To run the program without a printer 3-10
To run the program in manual mode 3-12
To set up the self test 3-13
To set up the dc offset test 3-14
To set up the noise test 3-15
To set up the spurious signals test 3-16
To set up the amplitude accuracy test 3-17
To set up the flatness test 3-18
To set up the amplitude linearity test 3-19
To set up the A-weight filter test 3-20
To set up the channel match test 3-21
To set up the frequency accuracy test 3-22
To Next Page
Loading...
Need help?
General
