To clean the screen
The analyzer’s display is covered with a plastic diffuser screen (this is not removable
by the operator). Under normal operating conditions, the only cleaning required will
be an occasional dusting. However, if a foreign material adheres itself to the screen,
do the following:
1
Set the power switch to off ( O ).
2 Remove the power cord.
3 Dampen a soft, lint-free cloth with a mild detergent mixed in water.
4 Carefully wipe the screen.
Caution Do not apply any water mixture directly to the screen or allow moisture to go behind
the front panel. Moisture behind the front panel will severely damage the instrument.
To prevent damage to the screen, do not use cleaning solutions other than the above.
To store the analyzer
• Store the analyzer in a clean, dry, and static free environment.
For other requirements, see environmental specifications in chapter 1,
‘’Specifications.’’
Agilent 35670A Preparing the Analyzer for Use
To clean the screen
2-17
To Next Page
Loading...
Need help?
General
