Chapter 5: Troubleshooting
To configure the motherboard jumpers and set up the BIOS
5–36
Table 5-7
Series 727 System Configuration Settings
* These configurations are only for instruments with 64 Mb or more of RAM.
7
Exit the Setup program, saving the changes you made.
The oscilloscope should now reboot and come up with the scope display. If it does not, recheck
your steps in the above procedure. If all the settings are correct, return to the Primary
Troubleshooting Procedure.
Configuration Item Setting
Load Optimal Defaults YES
Peripheral Setup (OnBoard Primary/Secondary IDE) Primary
Detect IDE Utility (Hard drive Primary Master) Data
Standard Setup—Date/Time Enter current values
Standard Setup—Floppy Drive A 1.44 MB, 3-1/2
Advanced Setup—System Keyboard Absent
Advanced Setup—External Cache Disabled
Power Management/APM* Enabled
Hard Disk Power Down Mode* Suspend
Hard Disk Time Out (minute)* 15 min
To Next Page
Loading...
Need help?
General
