Chapter 2: Preparing for Use
To connect an external monitor
2–10
5
Attach the 25-pin “D” connector to the serial input port of the printer. Tighten the
thumbscrews to secure the cable.
6 Set the printer configuration to use the serial interface. Refer to the User’s Quick Start
Guide for software installation instructions.
See the documentation for your printer if you have questions about configuring the printer to
use the serial interface.
To connect an external monitor
You can connect a VGA-compatible monitor to the Infiniium oscilloscope to provide a larger
viewing area.
• Connect the monitor cable to the display board video connector at the rear panel of the
oscilloscope. Tighten the retaining screws.
To connect the GPIB cable
• Attach the GPIB connector to the GPIB interface card connector at the rear of the
oscilloscope. Tighten the thumbscrews on the connector.
To Next Page
Loading...
Need help?
General
