1Introduction
Symbols
26 7000/7010 Series TQ GC/MS Operating Manual
Symbols
Warnings in the manual or on the instrument must be observed during all phases
of operation, service, and repair of this instrument. Failure to comply with these
precautions violates safety standards of design and the intended use of the
instrument. Agilent Technologies assumes no liability for the customer’s failure
to comply with these requirements.
Electromagnetic compatibility
This device complies with the requirements of CISPR 11. Operation is subject to
the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that
may cause undesired operation.
See accompanying instructions for more information.
Indicates a hot surface.
Indicates hazardous voltages.
Indicates earth (ground) terminal.
Indicates potential explosion hazard.
Indicates radioactivity hazard.
Indicates electrostatic discharge hazard.
Indicates that you must not discard this
electrical/electronic product in domestic household
waste.
To Next Page
Loading...
Need help?
General
