1260 Infinity Binary LC - System User Guide 83
Quick Start Guide
5
Preparing the System
Preparing the System
Turning the System ON
If the system is not already fully on with the software showing Ready
status, follow these steps:
1 Turn on the computer system and wait for the Windows desktop to
appear.
2 Turn on the electrical power to the LC modules using the button at the
lower left of each module.
A green power on light will be visible in the center of the button.
3 Start the control software on the computer by clicking the icon (if
configured). Alternatively, you can select Start > All Programs > Agilent
Technologies > OpenLAB > OpenLAB Control Panel. Select the relevant
instrument in the navigation pane under Instruments, and click Launch
online.
The ChemStation software opens in the Method and Run Control view. The
modules are initially in Standby mode and Not Ready status, except for
the autosampler which immediately initializes and becomes Ready.
4 To switch on each module individually, right- click the relevant icon and
select Switch [module name] on from the context menu.
Alternatively, you can turn on all modules simultaneously in the system
by clicking the System On/Off button in the bottom right of the system
diagram. The system status changes from Not Ready (yellow indication)
to Ready (green indication) after a short delay as the setpoints are
attained.
To Next Page
Loading...
