114 1260 Infinity Binary LC - System User Guide
6 Appendix
Setting Up a Method using Edit Entire Method
Instrument/Acquisition
Setup Instrument Method
The Setup Method screen can be directly accessed through the menu
Instrument > Setup Instrument Method..., or by right- clicking on the graphical
user interface on any module icon and then selecting Method... in the
context menu. This next stage in Edit Entire Method is the Setup Method
screen with six tab dividers for different modules or functions .
The tabs are:
• High Performance Autosampler (HiP-ALS)
• HiP-ALS Injector Program
• Binary Pump (BinPump)
• Thermostatted Column Compartment (TCC)
• Diode- array Detector (DAD)
• Instrument Curves
To move between the tabs, click on the tab name at the top of the screen.
When parameter changes have been entered they can be immediately sent
to the instrument by clicking Apply or when all tabs have been completed
clicking OK will send all parameters to the modules, close the screen and
move on to the next stage.
The parameter entry tabs look similar in all the control programs
(ChemStation, EZChrom, MassHunter et al.) due to the Agilent concept of
common RC.Net drivers for the instrument modules.
To run the example separation, as with most methods, it is not necessary
to change every available parameter but for completeness they are
described in the next sections.
To Next Page
Loading...
Need help?
General
