86 1260 Infinity Binary LC - System User Guide
5 Quick Start Guide
Preparing the System
3 In the Available Signals box, highlight the required signal(s), and click
Add to move them to the Selected Signals box.
4 To configure the individual settings for each signal, highlight the signal
in the Selected Signal box and set the required values in the lower half
of the page.
The Online Plot window behaves like electronic chart paper, continuously
recording the output from the detector(s) and other output parameters.
The signals are drawn at the right of the window and move away to the
left. Up to 90 min of past data is accessible. This is useful for checking
the baseline and looking at previous injections. The X and Y- axis scales
can be adjusted directly with the up/down buttons on each axis.
The Adjust button in the Online Plot window moves the current point on the
selected signal to the zero line. The selected signal is indicated by the
color of the Y- axis labels. A particular signal may be selected by clicking
on the signal or by clicking on the relevant signal description at the top of
the plot.
The Balance button zeroes all detectors when pressed.
In addition to the detector signals, parameter traces such as temperature and pressure can
also be plotted. With Apply to Method, the settings in this page can be stored into the
method.
Changes made in the Online Plot page do not in any way affect the data stored into the
individual data files.
To Next Page
Loading...
