Chapter 5 Error Messages
Execution Errors
119
5
-130
[1]
Suffix error
A suffix was incorrectly specified for a numeric parameter. You may have misspelled
the suffix or the numeric parameter does not accept a suffix.
Example: TRIG:DEL 0.5 SECS
-131
Invalid suffix
A suffix was incorrectly specified for a numeric parameter. You may have misspelled
the suffix.
Example: TRIG:DEL 0.5 SECS
-134
Suffix too long
A suffix for a numeric parameter contained too many characters.
-138
Suffix not allowed
A suffix was received following a numeric parameter which does not accept a suffix.
Example: STAT:QUES:ENAB 18 SEC (SEC is not a valid suffix).
-141
Invalid character data
Either the character data element contained an invalid character or the particular
element received was not valid for the header.
-144
Character data too long
The character data element contained too many characters.
-148
Character data not allowed
A discrete parameter was received but a character string or a numeric parameter was
expected. Check the list of parameters to verify that you have used a valid parameter
type.
Example: DISP:TEXT ON
-151
Invalid string data
An invalid character string was received. Check to see if you have enclosed the
character string in single or double quotes.
Example: DISP:TEXT ’ON
[1]This error message is only applicable for serial MY53xx6xxx.
To Next Page
Loading...
