Agilent Technologies E4448A User Manual

Chapter 2 89
Instrument Functions: A - L
Det/Demod
Instrument Functions: A - L
Key Path: Det/Demod
History: Added with firmware revision A.6.0
Remote Command:
See “Detector” on page 79.
Example: DET MPOS
2.4.1.11 RMS (Remote Command Only)
Selects the Average Detector. If
BW/Avg, Avg/VBW Type is set to Auto (or Pwr Avg) this will
yield the RMS voltage (average power) for each trace point. (See 3.4.1.3, Average)
Key Path: There is no key selection for this setting, but you can access it by using
Average Detector (see “Average” on page 83).
Remote Command:
See “Detector” on page 79.
Example: DET RMS

Agilent Technologies E4448A Specifications

General

Frequency Range	3 Hz to 50 GHz
VBW (Video Bandwidth)	1 Hz to 10 MHz
Sweep Time	1 ms to 1000 s
Phase Noise	-110 dBc/Hz at 10 kHz offset (1 GHz)
Resolution Bandwidth	1 Hz to 10 MHz
Display	Color LCD
Input Impedance	50 Ohm
Operating Temperature	0°C to 55°C
Amplitude Range	+30 dBm
Input VSWR	< 1.5:1
Input Connector	Type-N female
Power Requirements	100 to 240 VAC, 50/60 Hz