144
S:\Hp8960\Generic Documents\Manual Operation Getting Started Guide\Pi_manual operation getting started guide\chapters\gsm_man_measurements.fm
GSM Mobile Measurements
Measuring Phase and Frequency Error
1. Establish a call with the mobile.
2. Press the
Measurement selection key.
3. Select the Phase & Frequency Error measurement.
4. Press the Phase & Freq. Setup (
F1) key.
5. Set the measurement parameters as needed for your measurement situation,
including:
Measurement Timeout = 10 s
A typical phase and frequency error measurement result is shown above.
6. Press the Change View (
F2) key.
To Next Page
Loading...
Need help?
General
