44
3 Installing the Autosampler
Installing the Thermostatted Autosampler
Installing the Thermostatted Autosampler
Parts required # Description
1 Sampler and Thermostat
1 Power cord, for the other cables see below and “Cable Overview” on page 120
1 Control Software (ChemStation, EZChrom, OL, etc.) and/or Control Module G1323B.
Preparations • Locate bench space
• Provide power connection
• Unpack the Sampler and the Thermostat
WARNING
Module is partially energized when switched off, as long as the power cord is
plugged in.
Risk of stroke and other personal injury. Repair work at the module can lead to
personal injuries, e. g. shock hazard, when the module cover is opened and the
instrument is connected to power.
➔ Never perform any adjustment, maintenance or repair of the module with the top
cover removed and with the power cord plugged in.
➔ The security lever at the power input socket prevents that the module cover is taken
off when line power is still connected. Never plug the power line back in when cover
is removed.
WARNING
Damaged electronics
Disconnecting or reconnecting the autosampler to ALS thermostat cable when the
power cords are connected to either of the two modules will damage the electronics
of the modules.
➔ Make sure the power cords are unplugged before disconnecting or reconnecting the
autosampler to ALS thermostat cable.
To Next Page
Loading...
Need help?
General
