28 1100 Series WS MWS Reference Manual
1 Installing the Sampler
14 Connect the power cables to the power connectors.
15 Connect the CAN cable to other Agilent 1100 series modules.
16 If a Agilent ChemStation is the controller, connect either
• the GPIB cable to the detector
• the LAN connection to the LAN interface
17 Connect the APG remote cable (optional) for non Agilent 1100 Series
instruments.
18 Ensure the side panel is correctly installed.
19 Turn ON power by pushing the button at the lower left hand side of the
sampler.
20 Close the front door. The exhaust fan will turn ON and remove the vapor
from the tray compartment. After 1-2 minutes the sampler will start tile
hardware initialisation process. At the end of this process the status LED
should be green.
NOTE
The sampler is turned ON when the line power switch is pressed and the green indicator
lamp is illuminated. The detector is turned 0FF when the line power switch is protruding
and the green light is 0FF.
WARNING
To disconnect the sampler from the line, unplug the power cord. The power supply
still uses some power, even if the power switch at the front panel is turned 0FF.
WARNING
To avoid personal injury, keep fingers away from the needle area during autosampler
operation. Do not attempt to insert or remove a vial or a plate when the needle is
positioned.
To Next Page
Loading...
Need help?
General
