Agilent Technologies N9020A - Setting the BTS (Example)

Chapter 3 23
ACP Measurements
Setting the BTS (Example)
Setting the BTS (Example)
From the BTS and the system controller, set up a call using loopback
mode for the BTS to transmit the RF power as follows:
Frequency: 2.0 GHz
Output Power: −20 dBm
Carrier Number: 1
Switching Point: 3
Scramble Code: 0
Table 3-1 Timeslot Setup
Timeslot State
0On
1On
2On
3On
4Off
5Off
6Off
DwPTS On
UpPTS Off