22 Single-wheel power hoe 2100
Commissioning the Machine
Please note that durability and operational safety of the engine depend to a large
extent on its breaking-in. Always allow a cold engine to warm up for some minutes
and never run it at full throttle at the beginning.
Please note: for the first 20 hours of operation (break-in period) do not use the
engine at full power.
Make sure you check and maintain air filters regularly and use clean fuel.
Only use branded petrol.
Only use fresh, clean fuel (not older than 3 months) and approved fuel cans to be
purchased in special shops. Rusty sheet metal cans or fuel cans not suited for
petrol are not permitted.
For the first commissioning or after longer periods of no operation, fill fuel tank to
maximum to avoid starting problems.
Be careful when dealing with
fuel.
Fuel is easily inflammable and explo-
sive in certain conditions!
Do not refill in closed rooms.
Before each fuel fill, shut off the engine and
wait until it has cooled off.
Never refill close to open fire, inflammable
sparks or hot engine parts.
Do not smoke during filling!
Do not spill any fuel, use a proper filling de-
vice.
Do not cause fuel tank to overflow, but leave a 5
mm margin for the fuel to expand.
Each time you take up operation
Fill in engine oil up to the oil filling mark in the
pot of the oil bath air filter, filling quantity approx.
50 ml.
Control transmission oil level in mechanical gear-
box.
4. Commissioning and Operation
4
Ölstand
(Mix 1 : 25)
Mix 1 : 30
34
To Next Page
Loading...
