Single-wheel power hoe 2100 37
Storage
For longer periods of no operation
prepare the machine for storage. Pro-
ceed as follows:
a) Clean thoroughly
Repair paint coat.
b) Spray all shining parts and the hoe-
ing tools with Bio-slushing oil.
c) Engine preservation
Drain fuel completely or add fuel sta-
bilizer (agria-No. 799 09).
- Observe enclosed instructions.
Let engine run for approx. 1 minute.
Change the engine oil
Fill a tea-spoon of engine oil (approx.
0.03l) into the spark plug opening.
Slowly crank the engine.
Set the piston to compression via the
recoil starter (pull the starter grip until re-
sistance is felt) - valves are closed.
Slowly crank engine every 2–3 weeks
(spark plug connector disconnected).
Then set the piston to compresion again.
5. Maintenance
5
d) Drive-wheels
Support drive-wheels in such a way that
tyres have no ground contact. Pneumatic
tyres are quickly destroyed, if left stand-
ing under load and unsupported.
e) Clutch
Always park the machine with clutch le-
ver pulled (“0” –
pawl locked in
place). Otherwise,
clutch problems
may result due to
corrosion.
f) Storage
Because of severe corrosion
do not park the
machine
- in humid rooms
- in rooms where
fertilizer is stored
- in stables or adja-
cent rooms.
g) Protect machine
with cloth or a simi-
lar cover.
To Next Page
Loading...
