Single-wheel power hoe 2100 25
4. Commissioning and Operation
Change of work-site
Pull hand clutch lever.
Turn off tilling drive, position
“0”.
Move speed shift lever to
I
or
II
.
Slightly lift the rear of single-
wheel power hoe on the handle-
bar for tilling tools not to touch
the ground, max. 10 cm from
ground.
Slowly release hand clutch
lever while pressing the throttle
slightly – single-wheel power
hoe drives forward and tilling
tools stop turning.
End of Tilling
Set speed control lever to
idling position (min.)
Pull hand clutch lever and
hold
Move lever for gear shift and
tilling to position “0”
4
max 10 cm
min
To Next Page
Loading...
