32 Single-wheel power hoe 2100
Oil level
5. Maintenance
Tilling Drive
Check transmission oil level in tilling
drive before you commission the ma-
chine and after every 25 operating hours.
With the machine parked in horizontal
position (shown in figure) and with the
screw plug unscrewed, the oil level must
be visible in the filling opening. Add
transmission oil, if necessary.
Change transmission oil in tilling
drive after the first 25 operating hours
and then after every 50 operating hours.
Keep oil filler/drain screw and surround-
ing parts extremely clean to prevent dirt
from penetrating into the gearbox.
Dismount tilling drive.
Unscrew screw plug.
Turn gearbox round and collect trans-
mission oil in a proper container and dis-
pose of properly.
Turn back and mount tilling drive
again.
Fill in fresh transmission oil up to fill-
ing level (use appropriate filling tool,
such as funnel or something similar)
Srew down screw plug and tighten.
For oil quality and quantity, refer to
“Specifications”.
Drive-Wheel
Check tyre air pressure (0.8 bar)
frequently.
Oil level
5
25 h
(25 h) 50 h
To Next Page
Loading...
