Agria 2100 - Page 9

Single-wheel power hoe 2100 9
1. Safety Instructions
For any operation do not leave the op-
erator’s position as defined by the steer-
ing handle, especially not when you turn
the machine.
Riding on the attachment during opera-
tion or in transport is not permitted.
If clogging occurs in the attachment, turn
off the engine and clean the attachment
with an appropriate tool.
In case of damage to the single-wheel
power hoe or to the attachment, imme-
diately turn off the engine and have it
repaired.
If steering causes problems, immedi-
ately bring the single-wheel power hoe
to a halt and turn it off. Have the mal-
function removed without delay.
To prevent the single-wheel power hoe
from sliding on slopes make sure it is
secured by another person using a bar
or a rope. This person must be located
at a higher position than the vehicle at a
safe distance from the attachment at
work.
If possible, always work horizontally to
the slope.
End of Operation
Never leave the single-wheel power hoe
unattended with the engine running.
Before you leave the single-wheel power
hoe, turn off the engine. Then close fuel
tap.
Secure single-wheel power hoe against
unauthorized use – remove spark plug
connector.
Attachments
Only mount attachments with the engine
and attachment drive switched off.
Always use appropriate tools and wear
gloves when changing attachments and
parts thereof.
For mounting and dismounting attach-
ments bring support leg into proper po-
sition and ensure stability.
Secure single-wheel power hoe and at-
tachments against rolling off (wheel
wedge).
Beware of injuries when coupling attach-
ments. Proceed with extreme caution.
Mount attachments as specified and
only couple at specified points.
Secure single-wheel power hoe and at-
tachment against unauthorized use and
rolling off when you leave the machine.
If necessary, install transport or secu-
rity devices and secure.
Hoeing Attachment
Adjust protective hood of hoeing attach-
ment so that only those parts of tools
which penetrate the soil are not covered.
When hoeing, make sure hoeing skid is
adjusted properly.
1