10 agria Multi-Purpose Machine 400P
1. Safety Instructions
1
To prevent the machine from sliding on
slopes make sure it is secured by an-
other person using a bar or a rope. This
person must be located at a higher po-
sition than the vehicle at a safe distance
from the attachment at work.
If possible, always work horizontally to
the slope.
End of Operation
Never leave the multi-purpose machine
unattended with the engine running.
Before you leave the machine, turn off
the engine. Then close fuel taps.
Secure the machine against unauthor-
ized use. If tractor is equipped with an
ignition key, remove the key. For all other
versions, remove the spark plug connec-
tor to secure the tractor.
Attachments
Only mount attachments with the engine
and PTO switched off.
Always use appropriate tools and wear
gloves when changing attachments and
parts thereof.
To fit and remove attachments, bring the
support leg into proper position and en-
sure stability.
Secure the machine and attachments
against rolling off (parking brake, wheel
chocks).
Beware of injuries while coupling attach-
ments.
Couple the attachments as specified
and only couple at specified points.
Secure the machine and attachment
against unauthorized use and rolling off
when you leave the machine. If neces-
sary, install transport or safety devices
to provide protection.
Hoeing Attachment
Adjust the guards in such a way that only
the sets of blades penetrating the soil
are not covered.
When hoeing, make sure the depth bar
is adjusted properly.
Mowing Attachment
Handle with care! Sharp blades of the
cutter bar may cause injuries when han-
dled improperly! Remove knife guards
only for mowing and refit immediately
after work has finished.
For transport and storage always fit the
knife guards. Secure finger bars addi-
tionally with tension springs.
Do not transport the removed cutter bar
without knife guards.
When fitting/removing the cutter bar,
make sure all blades are protected by
the knife guards.
To exchange the knife and to fit/remove
the knife driver, make sure that you turn
screws and bolts away from the cutting
blades to remove them.
To grind the mowing knives, always wear
safety goggles and gloves.
Weights
Always fit weights properly and at speci-
fied points.
Maintenance
Never carry out any maintenance or
cleaning while the engine is running.
Before you work on the engine, always
remove spark plug connector (petrol
engine only).
To Next Page
