36 agria Multi-Purpose Machine 400P
4. Commissioning and Operation
4
Mowing: Danger zone
Hoeing: Danger zone
Operation
W
Check safety circuit function
- only operate the machine if
the safety circuit is working.
Wear individual pro-
tective ear plugs and
solid shoes.
l
Couple the attachment.
l
Set the correct ground speed for the
attachment.
l
Set drive-wheels to position “drive”.
l
Engage wheel drive via lever (C/11).
l
For pto-driven attachments: move pto
lever (A/1) to “I”.
l
Slightly pull on clutch lever (C/5), un-
lock pawl (C/6), release slowly and
press the throttle. The pto-driven at-
tachment starts moving and the multi-
purpose machine travels forward.
Reverse
l
Move speed control lever to IDLING.
l
Pull clutch lever (C/5) to middle po-
sition and wait until the machine stops
moving forward.
l
Pull clutch lever all the way up and
press the trottle at the same time.
W
If cleaning becomes necessary
during operation, shut off the
engine and remove spark plug con-
nector for safety reasons.
End of operation:
l
Disengage wheel-drive. To do this,
pull hand lever for wheel drive (C/11)
and lock pawl.
l
Pull clutch lever (C/5) and lock pawl.
l
For pto-driven attachments: Move the
pto-lever (A/1) to position “0”.
l
Turn off the engine.
W
Immediately re-install any
guards on the attachment
(e.g. knife guard on the cutterbar).
Danger zone
W
Keep out of the machine’s
danger zone during starts
and operation.
To Next Page
Loading...
