Agria 400P - Speed Control, Safety Circuit, and Choke

16 agria Multi-Purpose Machine 400P
3. Devices and Operating Elements
3
Speed Control Lever
The speed control lever (C/9) on the steering han-
dle is for stepless setting of engine speed from min.
= idle to max. = full throttle.
Safety circuit
The multi-purpose machine is equipped with a safety
circuit lever.
 Stop position: When releasing the lever (C/4)
the ignition system is switched off (engine is shut
off). Beware – engine keeps running due to cen-
trifugal mass.
 Start position: For starting the engine and
for short breaks, pull the clutch lever (C/5) and lock
with pawl (C/6).
 Operating position: To operate the machine,
press down the safety circuit lever (E/3 or G/3).
W
Do not tie down the safety circuit lever.
I
The safety circuit lever also serves as engine
safety circuit in an emergency. Upon release,
the lever will automatically go to STOP position.
Choke
The choke lever (B/5) is on the carburetor.
 Close the choke for cold starts. To do this, move
the lever to the left.
 Open the choke for warm starts and operation.
To do this, move the lever to the right.




