Agria 400P - Attachment Coupling and Decoupling

agria Multi-Purpose Machine 400P 27
3. Devices and Operating Elements
a Tensioning lever
b Tensioning band
c Stand
d Linkage
e Linkage pin
f Cap
3
Attachments
W
Only couple and decouple at-
tachments when the engine is
stopped. Secure attachments against
rolling off. Watch out to avoid getting
bruised when coupling the attach-
ment.
Front attachments
Most front attachments are attached to
the base machine by two tensioning de-
vices. Before you couple and decouple
the attachment park the machine on
level ground.
Coupling
l Move pto lever to “0”.
l Remove cap (f) from the pto.
l Rest the attachment on the stand (c),
if equipped.
l Bring tensioning bands into starting
position:
1. Move both tensioning levers (a)
to the rear,
2. pull both tensioning bands (b)
towards the side while you
3. move both tensioning levers
back to the front.
è 0