agria Multi-Purpose Machine 400P 33
4. Commissioning and Operation
4
R
4
Commissioning the
Machine
Please note that durability and opera-
tional safety of the engine depend to a
large extent on its breaking-in. Always
allow a cold engine to warm up for some
minutes and never run it at full throttle
at the beginning. Make sure the air filter
is serviced regularly and to use clean
fuel.
Please note: for the first 20 hours of
operation (break-in period) do not use
the engine at full power.
I
Note: For reasons of trans-
port, the machine is not filled
with engine oil!
Before you operate the
engine the first time, fill
in engine oil!
For this purpose, park the machine in
such a way that the engine is in a hori-
zontal position. For oil filling quantity and
quality refer to “Specifications”.
Check the oil level after filling.
Each time you take up operation
l
Check the engine oil level:
l
Remove the oil fill plug (B/11).
l
Clean the oil dip-stick with a clean
rag, insert it again but do not screw it
in.
l
Remove the dip-stick and read the
oil level. If necessary, fill engine oil up
to the level mark ”max” (fig. R).
Ensure the oil fill plug is tightly screwed
into the filler neck during engine opera-
tion.
l
Check whether sufficient fuel is
filled into the tank
Do not fill the fuel tank to the point of
spillage. Instead, top up fuel to the top
level mark to allow the fuel to expand.
W
Be careful when dealing with
fuel.
l
Fuel is easily inflammable and ex-
plosive in certain conditions!
l
Never refill close to open fire, inflam-
mable sparks or hot engine parts.
l
Do not refill in closed rooms.
l
Before each fuel fill, shut off the en-
gine and wait until it has cooled off.
l
Do not smoke during filling and
keep away from open fire and
sparks.
l
Do not spill
any fuel, use a
proper filling de-
vice. If fuel is
spilled on the
ground, ensure
the area is ab-
solutely dry and the vapours have
evaporated before you start the engine.
To Next Page
Loading...
