en | AHT Cooling Systems GmbH Unpacking | 7
409654_1_0120
33 / 458
▪
Do not expose the appliance to temperat-
ures higher than 70°C (158°F) during trans-
port and storage.
▪ Ensure good ventilation.
▪ Observe safety notices and warnings for
appliances with flammable refrigerants
(see →Flammable refrigerants).
▪ In the event of damage to the appliance,
promptly contact the maintenance service
(see →Maintenance services).
Transport of the appliances with indus-
trial trucks.
Risk of injury to persons in the event of a colli-
sion.
▪ Observe transport routes for industrial
trucks.
▪ Secure transported goods.
▪ Only trained personnel may operate indus-
trial trucks.
▪ Transport one appliance at a time with the
industrial truck.
NOTICE
Material damage caused by transport and
storage.
▪ Transport and store the appliance in a stable oper-
ating position (horizontal alignment).
▪ If the unit was tilted during transport, wait at least
two hours before starting it up.
▪ On delivery, ensure full accessibility to the installa-
tion point (observe clearance heights, clearance
widths, installation space height, sufficient turning
radii).
▪ Do not store the appliance outdoors.
▪ Storage: Do not stack the appliance.
7 Unpacking
Responsibility
– Operator
Check the appliance for damage before and during
unpacking.
In the event of damage, promptly contact the mainten-
ance service (see →Maintenance services).
WARNING
Dispose of packaging material and
film.
Suffocation hazard.
▪ Keep packaging material and film away
from children.
▪ Do not allow children to play with pack-
aging material or film.
Damage to the refrigerant circuit.
Flammable refrigerant can escape and cause
an explosive gas/air mixture. Fire hazard.
▪ Ensure good ventilation.
▪ Observe safety notices and warnings for
appliances with flammable refrigerants
(see →Flammable refrigerants).
▪ In the event of damage to the appliance,
promptly contact the maintenance service
(see →Maintenance services).
Appliance tipping hazard.
Persons may become trapped.
▪ Do not climb onto or into the unit.
▪ Read the instructions on the packaging.
▪ In the event of questions, contact the main-
tenance service (see →Maintenance ser-
vices).
CAUTION
Heavy appliance parts.
Hands may become trapped.
▪ Take care of fingers and hands when un-
packing.
▪ Use protective gloves.
NOTICE
Material and property damage due to missing
parts in the appliance.
▪ Check the packaging for loose parts.
▪ Do not dispose of loose parts; clarify their use with
the maintenance service (see →Maintenance ser-
vices).
8 Setup and installation
Responsibility
– Operator
For technical data see →Technical data
Do not cover the temperature display, safety notes, or
the rating plate (see →Rating plate and serial num-
ber).
WARNING
Appliance tipping hazard.
Persons may become trapped.
▪ Do not climb onto or into the unit.
▪ Read the instructions on the packaging.
▪ In the event of questions, contact the main-
tenance service (see →Maintenance ser-
vices).
Damage to the refrigerant circuit.
Flammable refrigerant can escape and cause
an explosive gas/air mixture. Fire hazard.
▪ Do not close the ventilation openings in the
unit housing. Only use original accessories.
▪ Only install the appliance in well-ventilated
rooms.
▪ Do not install the appliance in cellars or
lowered rooms.
▪ Ducts and wall bushings must be sealed
under and behind the unit to protect
against fire.
▪
The operator must not drill into the appli-
ance or carry out any other work on it.
▪ Do not squeeze or bend pipes.
To Next Page
Loading...
Need help?
General
