Aiphone IX SERIES - Page 125

125
Configuring the Station
■ Latch Reset
■ Change Call Destination
■ Call Failure
■ Begin Incoming Page
■ End Incoming Page
■ Begin Monitored
■ End Monitored
Description If "Relay Output" - “Function (→page 104)” is set to "Latch Output," a SIF command will be sent
when the flashing light is restored.
Settings • Checked: Send
• Unchecked: Do not send
Default values Unchecked: Do not send
Description A SIF command is sent from this station when there is a change in the call recipient linked with
the timer or schedule, or a change in the call recipient due to absent transfer, delay transfer, or
schedule transfer on the station that received the call.
Settings • Checked: Send
• Unchecked: Do not send
Default values Unchecked: Do not send
Description A SIF command is sent when an outgoing call fails.
Settings • Checked: Send
• Unchecked: Do not send
Default values Unchecked: Do not send
Description A SIF command is sent when incoming paging, message paging, or external input paging starts.
Settings • Checked: Send
• Unchecked: Do not send
Default values Unchecked: Do not send
Description A SIF command is sent when incoming paging, message paging, or external input paging ends.
Settings • Checked: Send
• Unchecked: Do not send
Default values Unchecked: Do not send
Description A SIF command is sent when the station starts being monitored by another station.
Settings • Checked: Send
• Unchecked: Do not send
Default values Unchecked: Do not send
Description A SIF command is sent when the station stops being monitored by another station.
Settings • Checked: Send
• Unchecked: Do not send
Default values Unchecked: Do not send