Chapter 3: Getting Started 19
The logging interval is the period over which the instrument will average the
logged sample. For example, if the logging interval is set to 30 minutes, each
sample will be the average over the previous 30 minutes. Log Interval is used
with Cont-Key/RunAvg and Cont-time/RunAvg logging modes.
This is the time over which the data will be -
mode of data logging.
The sum of all samples in a Test ID [SUM is only available for Capture Hood
or Diffuser Flow (flow from pressure and K-factor)].
The sample with lowest value in the Test ID.
The sample with highest value in the Test ID.
The SUM divided by the number of Samples.
To Next Page
Loading...