40 ProHood Capture Hoods PH730/PH731
Calibration Factor (Cf) Selection
The correction factor is an offset that can be applied to the velocity measurements when using the
AF Probe, Pitot tube and Velocity Matrix or flow when using the Capture Hood. An offset of ±50%
(0.50 to 1.50) can be applied to the measurement.
Depending on what is selected as the Pressure Tool will determine what measurement tool is displayed
on the Cf Selection screen.
Note
Calibration factors are not available for the Pressure Only or Flow/K-factor tools.
Calibration
The Calibration Menu lists measurement parameters that can be adjusted in the field. The appropriate
detachable probes must be attached to the meter before field calibration can be undertaken except for
pressure and barometric pressure calibration.
MENU
Pressure Tool
Display Setup
Flow Setup
Actual/Std Setup
Settings
Data Logging
Bluetooth Functions
Applications
Cf Selection
Calibration
CALIBRATION
Calibrate Temp
Calibrate Vel
Calibrate %RH
Calibrate Press
Calibrate B.P.
Calibrate Hood
Restore Factory Cal
To Next Page
Loading...
Need help?
General
