airmaster CV 80 - Page 16

16
Hardware
The condition of the individual components are monitored
and displayed in this menu.
Component functional = “OK”
Component with fault = “Fault”
Component not programmed = “N/A”
Components monitored:
Room temperature Room temperature sensor.
Inlet temperature Inlet temperature sensor.
Outside temperature Outside temperature sensor.
General.Purp.Temp. General purpose temperature
sensor.
Condenser Temp. Condenser temperature
sensor.
Evaporator Temp. Evaporator temperature
sensor.
Exhaust Temp. AHU Exhaust temperature sensor
air handling unit.
Outside Temp. AHU Outside temperature sensor
air handling unit.
Supply Flow Sensor 1 Supply Flow Sensor 1.
Supply Flow Sensor 2 Supply Flow Sensor 2.
Extraction Flow Sensor Extraction Flow Sensor.
CO2 Sensor CO
2
Sensor.
Supply Fan Supply Fan.
Extraction Fan Extraction fan.
Evaporator In Temp. Evaporator inlet temperature
sensor.
Evaporator Out Temp. Evaporator outlet tempera-
ture sensor.
Hot Gas Temperature Hot gas temperature sensor.
CC Connection Data connection to the cool-
ing module.
CC Stepdriver Step driver cooling module.
CC Frequency Inverter Frequency inverter cooling
module.
Humidity Sensor (out) Humidity Sensor (outside).
Humidity Sensor (in) Humidity Sensor (inside).
Installation Check
All units in the Airlinq system are identied and shown
in the order it is programmed. The Installation check will
show the following:
This Unit Type of unit that shows the
”Installation check”; PC or ID
number of the control panel.
Expected AHU’s Number of air handling units
expected in the system.
Online AHU’s Number of online air handling
units.
Sub-menu ”Online AHU’S”
Group ”x”, ID ”y” All groups complete with
air handling unit ID (ID =
identication number);
x = 0, 1, 2, ... or 19, y = 0, 1, 2,
... or 19.
If cooling modules are
installed the text “+CC ID”
is shown together with the
identication number of the
cooling module; 100, 101,
102, ... or 119
.
Sub-menu ”Online Control Panels”
ID ”z” Identication number of all
online control panels; z = 160,
161, 162, ... or 179.
Sub-menu ”Group Master N/A”
Group ”x”, ID ”y” See description above.