Akai QZ-503R Series

30
Moving tracks
The order of recorded tracks (songs) can be rearranged.
Track 1 Track 2 Track 3
re Asong B song C song
Tracks are - 7
Track 3 Track 4
B song C song
moved
1 Select the track number to be moved with the 10
key buttons.
Ex : When moving track number 4 to track number
2:
® Press the 4 button.
Playback of track 4 will start.
2 Press the JOIN/MOVE button to select “MOVE?”
“JOIN?” will appear on the FL display. Each time the
button is pressed the display will alternate between
“JOIN?” and “MOVE?”.
3 Press the SET button.
The number of where the track will be moved to will
flash on the FL display.
Track number where
track will be moved to
Track number of track t
to be moved
4 Use the JOG dial to input the track number where
the track will be moved to at the flashing track num-
ber.
5 Press the JOIN/MOVE button.
“MOVE!” will appear on the FL display, and playback
will start from the beginning of the moved track number
2.
M@ To cancel the move mode at any time during opera-
tion, press the CLEAR button.
Note:
@ When a track (song) is moved, its number will be changed
while it is being moved.
© Complete the move procedure before playback of the track
being moved finishes.
If the track is short, use the JOG dial to select the track
number, and carry out moving during the stop mode.
ENS efalialement(crs
Titles can be assigned to the recorded MD disc or tracks.
Titles can be created from letters symbols or numbers.
® When inputting disc titles, carry out the following pro-
cedure while the MD is in the stop mode.
® When inputting track titles, first select the number of
the track with the 10 key buttons or the JOG dial, then
carry out the following procedure.
4 Press the TITLE button.
“NAME IN?” will appear on the FL display.
vi
ay
2 Press the SET button.
The title input cursor will appear and flash.
3 Turn the JOG dial to select the letter for input at the
flashing cursor.
¢ Pressing the CHARA button will display the first char-
acter of available letters, numbers and symbols (A, a,
O, !) in order.
© Turning the JOG dial will display the characters within
the selected type in order as shown below.
aiphabet anialies) [AB E-XYZ
Alphabet (emaiters) | abe-xyz |
winbes SSS
Symbols DEORgoe
tela ela Pal
ite ti le t=|> ||
el] Te
4 Press the SET button to input the flashing charac-
ter.
The cursor will move to the next input position.
e To input a blank, press the SET button when there is
no character selected at the flashing cursor.
When a character is input at the cursor, it can be
erased by pressing the ERASE button.