Service Manual Aktilite
CL128
Version 1.
3
Page
6
of
41
1.4
Ligh
t module (128
-0-
750)
This light module comes as a ready
tested and
calibrated part. The dose factor in the
control electronics
and currents
(set in factoring mode) has to be adjusted according to
the documentation f
ollowing
the specific light module.
To determine the dose factor,
comprehensive tests has to be done with spectrometer and radiometer so this can only
be done at the factory. The dose factor is a factor that is a combination of wavelength
and irradiance and will vary slightly from light modu
le to light module.
1.5
Glue lenses
If one of the lenses is loose they can be glued on to the substrate using
Loctite 435
glue
.
To Next Page
Loading...