Service Manual Aktilite
CL128
Version 1.
3
Page 40
of 41
Step 8)
Place the four rubber pads (128
-1-
307) on the lower PS housing end cover, as shown on the
picture above.
Step 9)
Apply label (128
-1-
309) to the Power Supply
side wall.
4
Error Codes
The Aktilite CL128 has in
-
built monitoring features. If an error should occur, the display will show the
following message and five rapid beeps will be heard:
If an error code is displayed, or if any other unexpected condition occurs (e.g. lamp does not operate), the
following steps should be taken:
To Next Page
Loading...