Akuvox C319 Administrator's Guide

C319 Series Indoor Monitor Administrator Guide
www.akuvox.com
82
15 Door Access Control Configuration
15.1 Relay Switch Setting
15.1.1 Local Relay Setting
Local relays in the indoor monitor can be used to trigger relay for the door access and
trigger chime bell as needed in different scenarios. You can do this configuration on web
Device > Relay > Relay Setting interface.
Parameter Set-up:
• Relay Delay: set the relay delay time after the relay is triggered.
• Relay Type: set relay action type. There are two types of the relay, chime bell and
open door. Chime Bell, when there is a call, the chime bell will ring. Open door, when
press the unlock icon, the local relay will be opened.
• Remote Control: enable it to trigger local relay by DTMF and viceversa.
• DTMF: set the DTMF to trigger the local relay when you enable Remote control.
15.1.2 Remote Relay Switch Setting
You can use the unlock tab during the call to open the door on web Phone > Relay > Relay
Setting >Remote Relay interface. You are required to set up the same DTMF code in the
door phone and indoor monitor.

Akuvox C319 Specifications

General

Brand	Akuvox
Model	C319
Category	Monitor
Language	English