C319 Series Indoor Monitor Administrator Guide
Parameter Set-up:
•
DTMF Code: to set the DTMF code for the remote relay, which is # bydefault.
15.2
Web Relay Setting
In addition to the relay that is connected to the indoor monitor, you can also control the
door access using the network-based web relay. To do this configuration on web Device >
Relay > Web Relay interface.
Parameter Set-up:
•
IP address: enter the web relay IP address.
•
User Name: enter the User name provided by the web relaymanufacturer.
•
Password: enter the password provided by the web relay manufacturer. The
passwords are authenticated via HTTP and you can define the passwords using
HTTP get in Action.
•
Web Relay Action: enter the specific web relay action command provided by the web
manufacturer for different actions by the web relay.
To Next Page
Loading...
Need help?
General
