C319 Series Indoor Monitor Administrator Guide
Note
•
Please refer to the chapter Relay Switch Setting for the specific DTMF code
setting. Intercom devices involved must be consistent in the DTMF type,
otherwise, DTMF code cannot be applied.
•
Payload: select payload 96-127 for data transmission identification.
15.3.2
Door Unlock via HTTP Command
You can unlock the door remotely without approaching the device physically for the door
access by typing in the created the HTTP command (URL) on the web browser to trigger
the relay when you are not available by the door for the door access. To do this
configuration on web Intercom > Relay > Open Relay via HTTP interface.
Parameter Set-up:
•
Switch: enable it to allow the relay to be triggered remotely using HTTP command.
•
Username: enter the device username to be used as a part of the HTTP command to
trigger the local relay. For example, admin.
•
Password: enter the device password to be used as part of the HTTP command to
trigger the local relay. For example, 12345. Please refer to the following example:
http://192.168.35.127/fcgi/do?
action=OpenDoor&UserName=admin&Password=12345&DoorNum=1