X933 Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com
Device Location: enter the location in which the device is installed and
used.
10.3. Device NAT Setting
NAT (Network Address Translation) allows hosts in an organization’s private
intranet to transparently connect to hosts in the public domain. There is no
need for internal hosts to have registered Internet addresses. It is a way to
translate the internal private network IP address into a legal network IP
address technology. To set up NAT, you can do it on web Account >
Advanced > NAT interface.
Parameter Set-up:
UDP Keep Alive Messages: if checked, the device will send out the
message to the SIP server so that SIP server will recognize if the device
is in online status.
UDP Alive Msg Interval: set the message sending time interval from 5-60
seconds, the default is 30 seconds.
RPort: check the RPort when the SIP server is in WAN (Wide Area
Network).
To Next Page
Loading...
Need help?
General
