Akuvox X933 Series User Manual

X933 Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com
88
 Call: enable Call if you want you a call to go to a designated SIP or IP
number.
14.2.7.2. Configure Alarm Action via HTTP Command
To set up the HTTP Command action, you can click “Enable”in the Send HTTP
field to enable the actions for the alarm sensor installed in different locations.
Then enter the HTTP command provided by the manufacturer of the device
on which the action is to be carried.
14.2.7.3. Configure Alarm Action via SIP Message
To set up the SIP message action receiver on the same web interface. Enter
the SIP account to which you want to send the configured SIP message as
an action when the alarm is triggered.

Akuvox X933 Series Specifications

General

Brand	Akuvox
Model	X933 Series
Category	Intercom System
Language	English