X933 Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com
Export Debug Log: click the Export tab to export debug log file to a local
PC.
Remote System Log: select “Enable” or “ Disable” if you wan to enable or
disable the remote system log.
Remote System Server: enter the remote server address to receive the
the device And the remote server address will be provide by Akuvox
technical support.
22.2. PCAP for Debugging
PCAP in Akuvox indoor monitor is used to capture the data package going in
and out of the devices for debugging and troubleshooting purpose. You can
set up the PCAP on the device web Upgrade > Advanced > PCAP interface
properly before using it.
Parameter set-up:
Specific Port: select the specific ports from 1-65535 so that only the dat
a packet from the specific port can be captured. You can leave the field bl
ank by default.
PCAP: click ”Start” tab and ”Stop” tab to capture the a certain range of d
ata packets before clicking Export tab to export the data packets to you L
ocal PC.
PCAP Auto Refresh: select “Enable” or “ Disable” to turn on or turn off the
PCAP auto fresh function. If you set it as “Enable” then the PCAP will
To Next Page
Loading...
Need help?
General
