GB
42
Repair
stopped in wet and heavy snow and then re-
started. Do not release the clutch lever for
the auger drive!
2. Change gear with gear lever (44/1).
3. Push clutch lever (42/5) for the travel drive
(42/a).
7.4 Selecting operating mode at 760 TE
The operating mode lever (02/23) can be used to
adjust the height of the transport auger, clearing
plate and plough by displacing the weight of the
snow blower.
■
"Transport": The weight lies on the rear area
of the snow blower, so that the transport au-
ger and plough are away from the ground
and the snow blower can be easily pushed.
■
"Normal": Horizontal position of the snow
blower for normal operation.
■
"Packed Snow": With dense snow, the weight
can be moved to the front area of the snow
thrower with this setting.
7.5 Steering the 760 TE snow blower (45)
1. Steering the snow blower to the left: Tighten
the left tilt lever (45/1) (45/a).
2. Steering the snow blower to the right: Tighten
the right tilt lever (45/2) (45/b).
7.6 Clearing clogging in the snow discharge
spout (43, 46)
NOTE Allow the transport auger to run at all
times, if possible, in order to avoid clogging in
heavy and wet snow.
If the snow is no longer discharged correctly,
snow and ice deposits on the transport augers
and in the discharge channel may be the cause.
1. Release the clutch lever (43/1) to disengage
the auger drive and travel drive (43/a).
2. Switch off the engine (see chapter 6.8 "Stop-
ping the engine (38, 39)", page41).
3. Carefully clear the snow from the discharge
channel and transport auger using the clean-
ing tool (46/1).
If the snow discharge is still unsatisfactory, take
the appliance to a specialist workshop.
8 REPAIR
WARNING! Risk of injury during repair
work. Improper repairs can lead to serious inju-
ries and damage to the appliance.
■
Have repair work performed by the manufac-
turer's service centres and authorised spe-
cialist companies only!
A professional inspection is always required:
■
After colliding with an obstacle.
■
If the engine stops suddenly.
■
If the transport auger or discharge wheel are
damaged.
9 MAINTENANCE AND CARE
CAUTION! Risk of injury. Sharp-edged
and moving appliance parts can lead to injury.
■
Always wear protective gloves during mainte-
nance, care and cleaning work!
■
Switch off the engine and check that the en-
gine is at a standstill!
■
Remove the spark plug connector!
■
Clean the appliance after every use. In partic-
ular, remove any residues of road salt.
■
Do not spray the appliance with water. Pene-
trating water can lead to malfunctions (igni-
tion system, carburettor).
■
Always replace a defective silencer.
■
Observe the maintenance schedule.
■
Observe the engine operating manual.
9.1 Maintenance schedule
Before every use
■
Check the oil level (see engine operating
manual).
■
Check the shear pins.
■
Inspect the appliance for damage.
■
Check whether the transport auger is frozen.
After the first 5 operating hours
■
Change the engine oil (see engine operating
manual).
Every 8 operating hours
■
Grease the transport auger.
Every 3 months
■
Check the tyre pressure.
■
Oil the ring of the snow discharge spout with
spray oil.
To Next Page
Loading...
