3. Display the protection group for the associated shelf/slot/port on the far end NE, as
determined in item1 above. This is the port at the end of the protection group
currently
configured for uni-directional switching.
CLI config aps group [y] detail
4. Change the protection mode to bi-directional.
CLI config aps group [y] direction bi
AUTHFAIL
AUTHFAIL (Authentication Failure)
The AUTHFAIL autonomous message is issued after an invalid login attempt is detected.
Severity TC
Service affecting? No
Applicability SYSTEM
No corrective action is required. This is a normal report caused by an invalid login
attempt.
Trouble-clearing procedures
APSMM
APSMM (APS Mode Mismatch)
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
2-43
E ND OF STEPS
...................................................................................................................................................................................................
To Next Page
Loading...
